AMAADOR ACADEMYCertificatesVerify a certificate

8DA3

Final check — 8D Problem Solving and the A3 Report

Answer the 26 questions. You need 80% or more to pass. You can retry as many times as you like.

Study the course →

Question 1Which company first published the 8D method, in its 1987 Team Oriented Problem Solving manual?
Question 2An operator finds one label stuck upside down, re-sticks it and the cause is obvious: a roll loaded the wrong way, corrected at once. No customer is affected. What is the right level of response?
Question 3What does ISO 9001:2015 clause 10.2 require when a nonconformity occurs?
Question 4A plant wants to cut changeover time on a moulding press from 50 to 20 minutes. There is no customer complaint. Which tool fits best?
Question 5A customer reports 25 pumps leaking. Before forming the team, the quality engineer asks for the parts, photos, labels and quantities. Which 8D step is this?
Question 6Mehdi is forming an 8D team on a defect at a welding station. Which team is the best choice?
Question 7Which of these is a good D2 problem statement?
Question 8Is / is not shows the defect IS on product P-10 made on press 2, and IS NOT on P-10 made on press 1 with the same material. What does this suggest?
Question 9What is the purpose of an interim containment action (D3)?
Question 10A sorting company will check 20,000 parts for a hidden internal crack. The plan says "visual inspection by the sorting team". What is the main weakness?
Question 11After sorting, a supplier puts a green dot on every certified box. What is the main reason?
Question 12To check that sorters really catch the defect, a team leader slips five known bad parts into a batch. What is this practice?
Question 13In an 8D, what does the escape (non-detection) root cause explain?
Question 14A 5 Whys chain ends with "The operator was not paying attention." What should the team do?
Question 15The team believes a new resin batch causes short shots. Which evidence best confirms it as the root cause?
Question 16In an Ishikawa diagram, which family would "gauge not calibrated" belong to?
Question 17Operators sometimes fit a left-hand part on a right-hand assembly. Which permanent corrective action is strongest?
Question 18What is the difference between verification (D5) and validation (D6) of a corrective action?
Question 19To fix a root cause, an automotive supplier wants to switch to a new steel grade next week. What must it check first?
Question 20Two weeks after a new pull test was installed, no complaint has arrived. The test has never been tried on a known bad part. Can containment be lifted?
Question 21Which documents does IATF 16949 clause 10.2.3 expect you to review and update during problem solving?
Question 22The root cause was a supplier changing a material without notice. The fix worked on product A. Products B and C use parts from the same supplier. What is the best D7 action?
Question 23What happens in D8?
Question 24On an A3 report, which part corresponds to the "Plan" stage of PDCA?
Question 25Sara's A3 title reads "Install a second conveyor". What is wrong with it?
Question 26Omar finished his 8D for a customer and must brief the plant leadership in ten minutes. What is a good approach?