AMAADOR ACADEMYCertificatesVerify a certificate

I40

Final check — Industry 4.0 and Smart Factory Basics

Answer the 24 questions. You need 80% or more to pass. You can retry as many times as you like.

Study the course →

Question 1What is a cyber-physical system in a smart factory?
Question 2A manager says: “Let’s buy every Industry 4.0 technology this year so we are not left behind.” What is the best reply?
Question 3On the ISA-95 (IEC 62264) model, where does a PLC that controls a machine belong?
Question 4IT wants to link the office network directly to the production network so the ERP can read machine counts. What new risk should the team raise first?
Question 5A press must stop within milliseconds when a sensor detects an abnormal force, even if the internet link fails. Where should that logic run?
Question 6What is OPC UA?
Question 7Two lines send temperature data to the same dashboard. One sends °C, the other °F, both labelled “Temp”. What is the main problem?
Question 8Which statement about IIoT on older machines is correct?
Question 9A shift is planned for 400 minutes. The machine runs 360 minutes, at full ideal speed, and all parts are good. What is its OEE?
Question 10A line shows availability 95%, performance 70% and quality 99%. Where should the team look first?
Question 11What is the aim of condition monitoring within the P-F interval?
Question 12To improve the OEE figure, a supervisor proposes removing changeover time from planned production time. What is wrong with this?
Question 13A cobot cell has no fence. An operator notices the area scanner has been covered with tape “because it stopped the robot too often”. What should she do?
Question 14Which statement about cobot safety is correct?
Question 15A machine-vision system trained on parts from supplier A starts rejecting many good parts after the plant switches to supplier B. What is the most likely cause?
Question 16What does Regulation (EU) 2023/1230 on machinery add for software that ensures safety functions?
Question 17In shop-floor OT, what usually comes first in security decisions?
Question 18During a night shift, the HMI cursor moves by itself and set points change without anyone touching them. What should the operator do first?
Question 19Your phone battery is low and the only free USB port is on a packaging machine’s operator panel. What is the right choice?
Question 20In ISA/IEC 62443, what are “zones” and “conduits”?
Question 21A plant wants to install an energy-monitoring system on all its lines. Nobody has measured current energy use per part. What should come first?
Question 22A digital pilot on line 2 ends: OEE did not improve, but the team learned stop reasons were badly recorded. How should this be judged?
Question 23Which three values does the European Commission put at the centre of Industry 5.0?
Question 24A Moroccan plant plans cameras on the line that can identify each operator, to “measure productivity”. What must the project team handle?