AMAADOR ACADEMYCertificatesVerify a certificate

JHA

Final check — Job Hazard Analysis (JHA / JSA) in Practice

Answer the 24 questions. You need 80% or more to pass. You can retry as many times as you like.

Study the course →

Question 1Which statement best describes a Job Hazard Analysis (JHA)?
Question 2A technician arrives at a pump with a valid permit and a briefed JHA. He notices that the drain line next to the pump is still dripping, which the JHA did not mention. What tool is he using when he stops to think about this?
Question 3Your site has time to write three new JHAs this month. Which job should come first according to OSHA 3071 priorities?
Question 4How do a permit to work and a JHA relate to each other?
Question 5A JHA for replacing a conveyor belt has one step: “Replace the belt”. What is the main problem?
Question 6What is the best way to build the step list for a JHA?
Question 7A JHA for changing a hydraulic hose on an excavator starts with “unscrew the hose fitting” and ends with “tighten the new fitting”. Which step is most clearly missing?
Question 8A supervisor's JHA for a pipe flange change has 34 steps, including “pick up spanner” and “walk to the flange”. What should he do?
Question 9During the step “open the electrical panel to reset a relay”, which energy prompt points to the most serious hazard?
Question 10Which hazard entry is written in the most useful way?
Question 11A crew will replace a spring-loaded safety valve on a vessel that has been isolated and drained. Which hazard is easiest to miss but serious?
Question 12Why should the energy prompts be applied to each step rather than once for the whole job?
Question 13On a 5×5 matrix, a hazard is rated likelihood 3 and severity 4. What is the score, and in the example bands what does it mean?
Question 14A JHA covers inspecting the fittings on a storage tank roof that has no edge protection. Four controls are proposed for the fall hazard. Which one sits highest in the hierarchy of controls?
Question 15On a JHA, a step is rated 3×5 = 15 before controls. The only control added is safety glasses, and the writer rates the residual risk 1×2 = 2. What is wrong?
Question 16Which control is written in a way the crew and supervisor can actually check?
Question 17What does the 5-column JHA form add compared with the 3-column form?
Question 18Reviewing a draft JHA, you see “fire extinguisher at hand” as a control on the step “remove the coupling guard”, but no fire hazard is listed anywhere. What should the writer do?
Question 19In the pump seal example, step 2 (isolate and lock the pump) goes from 3×5 = 15 to 1×5 = 5. A trainee asks why severity is still 5. What is the right answer?
Question 20Which item belongs in the JHA header rather than in the step lines?
Question 21A supervisor collected all the JHA signatures in the canteen at breakfast. At the pump, one technician cannot say which locks go on before the casing is opened. What should happen?
Question 22Halfway through a job, the operator reports that the discharge valve will not close fully. The JHA assumed a tight isolation on that valve. What should the crew do?
Question 23When you review a JHA written by someone else, which is the clearest sign that it was copied and pasted?
Question 24An annual shutdown task will use last year's approved JHA. Nobody knows of any change to the equipment or method. What is the right approach?