AMAADOR ACADEMYCertificatesVerify a certificate

MCGDT

Final check — Metrology, Calibration and GD&T Basics

Answer the 24 questions. You need 80% or more to pass. You can retry as many times as you like.

Study the course →

Question 1According to the VIM, what does metrological traceability require?
Question 2A digital caliper shows 0.03 mm when its jaws are fully closed and clean. Every reading you take will be about 0.03 mm too high. What kind of error is this?
Question 3A supplier says its new gauge is very accurate because the display shows four decimal places. What is the best reply?
Question 4Since the 2018 revision of the SI, how are the seven SI base units defined?
Question 5You must check a bore of Ø30 +0.021 / 0 mm. Which instrument fits the 10:1 rule of thumb?
Question 6What is the standard reference temperature for dimensional measurement set by ISO 1?
Question 7An operator measures a shaft by holding the micrometer frame in his bare hand for several minutes and spinning the thimble hard. What is the main problem?
Question 8In production, holes are checked with a go / no-go plug gauge. The go end enters and the no-go end also enters. What does this mean?
Question 9According to the VIM, how does calibration differ from adjustment?
Question 10You pick up a height gauge whose calibration label expired two weeks ago. The job is urgent. What should you do?
Question 11A calibration certificate lists results at each point but gives no measurement uncertainty. What is the main concern?
Question 12Under ISO 9001:2015 clause 7.1.5, what must you do when measuring equipment is found unfit for its intended purpose?
Question 13A result is reported as 25.012 mm ± 0.004 mm (k = 2). What does the 0.004 mm represent?
Question 14You estimate uncertainty from the standard deviation of ten repeat readings, and add the value from the calibration certificate. Which GUM types are these?
Question 15A diameter is specified 10.00 to 10.10 mm. Your method has U = 0.02 mm and the ISO 14253-1 default rule applies. Which reading proves conformity?
Question 16Too many good parts end up in the grey zone near the limits. The method has a large uncertainty compared with the tolerance. What is the best fix?
Question 17A dimension is written 40 +0.1 / −0.05 mm. What is its tolerance?
Question 18A drawing calls for a bush pressed into a housing as a permanent assembly, hole basis. Which fit code would you expect to see?
Question 19A dimension on a drawing is shown in brackets: (65). The inspector wants to reject the part because it measures 65.6 mm. What is correct?
Question 20What does the title block note ISO 2768-mK call up?
Question 21Which geometric tolerance is a form control and never needs a datum?
Question 22A pin is specified Ø6.00 to Ø5.90 with position Ø0.05 Ⓜ. It measures Ø5.94. What position tolerance is allowed for this pin?
Question 23A feature control frame reads: position Ø0.2 | A | B | C. In what order should the inspector set the part on the datum simulators?
Question 24A European drawing states ISO 8015 and shows a shaft Ø20 h7 with no envelope symbol. A US colleague says the shaft must have perfect form at maximum size. What is correct?