AMAADOR ACADEMYCertificatsVérifier un certificat

ARCF

Test final — Sensibilisation au risque d’arc électrique (NFPA 70E)

Répondez aux 24 questions. Il faut 80 % ou plus pour réussir. Vous pouvez réessayer autant de fois que vous le souhaitez.

Ce test final est disponible en anglais.

Suivre la formation →

Question 1How does an arc flash differ from an electric shock?
Question 2According to OSHA, what mainly determines how much energy an arc flash releases at the worker?
Question 3After a minor arc at a 208 V panel, an operator says: "It's only 208 volts, so the arc couldn't have been dangerous." What is the best reply?
Question 4A worker standing near a switchboard during a fault is wearing a polyester shirt. Which outcome is the most likely cause of a severe burn, according to OSHA?
Question 5What is the relationship between OSHA and NFPA 70E in the United States?
Question 6An experienced electrician who usually works on lighting circuits is asked to rack out a medium-voltage breaker he has never operated. What applies?
Question 7Under NFPA 70E, how often at a minimum must safety-related work practice training be repeated?
Question 8What does HSE UK say about working on live electrical equipment?
Question 9In the NFPA 70E hierarchy of risk controls, which control comes first?
Question 10A hospital asks electricians to work on a panel that feeds life-support equipment in an intensive care unit, which cannot be switched off. Under OSHA 1910.333, how can energized work be justified here?
Question 11A site wants to reduce incident energy at a main switchboard where electricians often rack breakers. Which measure is an engineering control?
Question 12Which item is a required element of an NFPA 70E energized electrical work permit?
Question 13What does the arc flash boundary represent?
Question 14A label shows incident energy of 8.5 cal/cm² at a working distance of 457 mm. To reach a terminal, the electrician will have his face about 250 mm from the bus. What is true?
Question 15A cleaner needs to mop the floor 2 m from an open 480 V panel where a qualified electrician is testing. The arc flash boundary is 2.5 m. What should happen?
Question 16An electrician finds that the arc flash label on a panel is dated seven years ago and the site has since replaced the upstream transformer. What should he do?
Question 17What is the minimum arc rating for NFPA 70E arc flash PPE category 2?
Question 18A team wants to use the NFPA 70E PPE category table for a panel, but nobody knows its available fault current or protective device clearing time. What applies?
Question 19On a cold day an electrician wants to wear his own fleece jacket over his arc-rated shirt while working inside the arc flash boundary. What is the correct advice?
Question 20Under the incident energy analysis method, how is arc-rated clothing selected?
Question 21When is a circuit in an electrically safe work condition?
Question 22An electrician is about to test for absence of voltage on a 480 V bus after locking out. What PPE should he wear for this test?
Question 23A colleague has just suffered an arc flash in a switch room. He is on the floor near the open panel and the breaker has not tripped. What should you do first?
Question 24In the 2020 wind farm substation flashover prosecuted by HSE, what did the investigation identify as the cause?